Toyota / Lexus 1-Pin 2.2mm Starter Motor Waterproof Connector – OEM 90980-11400 / 6189-0413
Direct OEM-specification replacement for the Sumitomo 1-pin waterproof wire harness connector used on starter motor control circuits across Toyota and Lexus platforms. Cross-references Sumitomo / Toyota OEM part numbers 90980-11400 and 6189-0413. Uses the 2.2mm contact series in black nylon and rubber housing with waterproof sealing — the single pin carries the ignition switch signal to the starter motor solenoid, triggering engine cranking when the key is turned or the start button is pressed.
A failed connector causes a no-start condition — the engine will not crank when the ignition key is turned or the start button is pressed, even though the battery is fully charged. This is a common misdiagnosis: the starter motor and battery are replaced before the single-pin connector is inspected. A corroded or open 1-pin starter connector is a quick and inexpensive fix for a no-start fault.
| OEM Number | Application |
|---|---|
| 90980-11400 | Toyota 1-pin starter motor connector (primary) |
| 6189-0413 | Sumitomo 1-pin starter motor connector (alternate) |
| Attribute | Detail |
|---|---|
| Pin Count | 1-Pin |
| Contact Series | 2.2mm pitch (Sumitomo series) |
| Housing Material | Nylon and rubber (waterproof) |
| Housing Colour | Black |
| OEM Part Numbers | 90980-11400 / 6189-0413 |
| Applications | Starter motor solenoid control circuit |
| Compatible Models | Toyota Corolla / Camry / RAV4 / Hilux / Land Cruiser / HiAce; Lexus IS / GS / RX / LS |
| Terminal Included | Yes |
Q: My Toyota will not crank at all — battery is good, could it be the starter connector?
A: Yes. Test for 12V at the starter solenoid terminal when the key is in the crank position — if there is no voltage, trace back to the 1-pin connector (OEM 90980-11400) before replacing the starter motor.
Q: Are terminals included?
A: Yes, terminals are included with all variants.
Be the first to know about new collections and special offers.
Automotive connector
