Deutsch DT Connector with 15cm Pre-Wired Harness Pigtail – DT06-2S / DT04-2P, 2–12 Pin

Pre-wired Deutsch DT connector pigtails eliminate the need for crimp tooling in the field — the connector housing is factory-assembled with 15cm of pre-terminated wire leads, ready to splice directly into an existing harness using butt connectors, solder, or heat-shrink splice connectors. This is the fastest solution for sensor replacement, harness repair, and OEM connector matching when a dedicated Deutsch crimp tool is not available on-site.

Key Specifications

• Connector Series: Deutsch DT (DT06-2S female / DT04-2P male, and larger pin counts)
• Pin Configurations: 2, 3, 4, 6, 8, 12 pin (select above)
• Wire Length: 15cm per lead
• Wire Gauge: 16–22AWG (size 16 contacts)
• IP Rating: IP67 (mated)
• Contact Size: Size 16 (13A per pin)
• Operating Temperature: -55°C to +125°C
• Quantity: 5, 20, or 100 sets (select above)

Pre-Wired Pigtail vs Field-Assembled Connector — When to Use Each

• Pre-wired pigtail (this product): No crimp tool required. Splice the pigtail leads into the existing harness. Fastest solution for field repairs and sensor replacement. Ideal when only a few connectors are needed and purchasing a dedicated crimp tool is not justified. Slightly higher cost per connector than field-assembled.
• Field-assembled (housing + contacts + crimp tool): Lower cost per connector at volume. Requires a Deutsch HDT-48-00 or equivalent ratchet crimp tool. Best for production harness assembly, fleet maintenance, and any application requiring more than 10–20 connectors.

What Questions Does This Product Answer?

• "How do I splice a pre-wired Deutsch pigtail into an existing harness?" — Cut the existing harness wire at the repair point, leaving sufficient length. Strip both the pigtail lead and the harness wire to 10–12mm. Join using a butt splice connector (heat-shrink type recommended for waterproofing) or solder + heat-shrink tubing. Ensure the splice is mechanically supported to prevent stress on the joint.
• "Can I extend the 15cm leads?" — Yes. Splice additional wire to the pigtail leads using the same gauge wire and waterproof butt connectors. Maintain the same wire color coding to avoid wiring errors during future maintenance.
• "Are the contacts in pre-wired pigtails the same as standard DT contacts?" — Yes. Pre-wired pigtails use the same Deutsch size 16 contacts as field-assembled connectors. The housing, contacts, and wedge locks are identical to standard DT components.
• "What wire colors are used in the pigtail leads?" — Wire colors vary by manufacturer. Common color schemes: 2-pin = red/black; 3-pin = red/black/white; 4-pin = red/black/white/green. Verify the color code of your specific pigtail before splicing into a color-coded harness.

Typical Applications

• Sensor replacement: Replacing damaged OEM sensor connectors on agricultural, construction, and automotive equipment without a crimp tool
• Harness repair: Restoring damaged connector ends on existing harnesses in the field
• Custom harness building: Adding Deutsch connectors to custom wiring without investing in crimp tooling
• Prototype wiring: Rapid prototyping of harness designs before committing to full field-assembly tooling

Package Contents

5, 20, or 100 sets (select above) — each set: 1× DT06 female housing with 15cm pre-wired leads + 1× DT04 male housing with 15cm pre-wired leads, pin count as selected.