Mitsubishi 7-Pin Meter Wire Harness Connector – OEM 08061010 | Lancer / Outlander / Pajero

The OEM 08061010 is a 7-pin connector used in Mitsubishi instrument cluster (meter) harnesses across the Lancer, Outlander, and Pajero model lines. Mitsubishi’s meter harness carries a dense mix of circuits through this single connector: vehicle speed signal, tachometer pulse, fuel gauge sender, coolant temperature gauge, warning light inputs, illumination, and ground. Because all gauge and warning circuits pass through this one connector, a single corroded terminal can cause multiple simultaneous gauge failures – a pattern that is often misdiagnosed as a failed instrument cluster. Available bare or with 15cm pre-wired leads.

Key Specifications

Meter Connector Failure – The Multi-Gauge Misdiagnosis Trap

When a Mitsubishi meter harness connector corrodes, the failure pattern is deceptive. Because the 7-pin connector carries multiple gauge circuits, corrosion on a shared ground or power pin causes all gauges to read incorrectly simultaneously – the speedometer drops to zero, the fuel gauge reads empty, and the temperature gauge pegs at maximum, all at the same time. This pattern is frequently misdiagnosed as a failed instrument cluster, leading to unnecessary cluster replacement. Before condemning the cluster, always inspect and test the OEM 08061010 meter connector for corrosion, pushed-back terminals, or housing damage. A connector replacement is a fraction of the cost of a cluster replacement.

Variant Guide

• Female – Bare 7-pin housing with terminals
• Female 15CM – Pre-wired with 15cm leads for direct splice-in installation

Installation Steps

1. Disconnect the vehicle battery
2. Remove the instrument cluster from the dashboard (typically 4 screws and 1–2 connectors)
3. Locate the OEM 08061010 7-pin meter connector on the cluster harness
4. Release the locking tab and unplug the original connector
5. Inspect all 7 terminals for corrosion or pushed-back contacts
6. Transfer terminals to the new housing or splice in the pre-wired variant
7. Reinstall the cluster and verify all gauge functions before closing the dashboard

Frequently Asked Questions

Q: What Mitsubishi models use OEM 08061010?
A: OEM 08061010 is used on Mitsubishi Lancer (CS/CY/CZ), Outlander (CW/GF), and Pajero (V60/V80) instrument cluster harnesses. Cross-reference your vehicle’s wiring diagram to confirm fitment for your specific model year.

Q: My speedometer and fuel gauge both failed at the same time – is it the connector?
A: Multiple simultaneous gauge failures on Mitsubishi platforms are a strong indicator of a meter connector issue rather than a failed cluster. Inspect the OEM 08061010 connector first before replacing the instrument cluster.

Q: Are terminals included?
A: Yes, terminals are included with all variants.

Compatible Applications

• Mitsubishi Lancer CS / CY / CZ – Instrument cluster meter harness
• Mitsubishi Outlander CW / GF – Meter connector
• Mitsubishi Pajero V60 / V80 – Instrument cluster wiring