6-Pin Sumitomo Waterproof Throttle Pedal Sensor Connector – OEM 6195-0021 / 6195-0024

Direct-fit replacement for Sumitomo part numbers 6195-0021 (female housing) and 6195-0024 (male housing), a 6-pin IP68 waterproof connector set used for accelerator pedal position sensor (APPS) and electronic throttle control (ETC) harness connections. The dual-redundant 6-pin design provides two independent signal channels for safety-critical throttle-by-wire systems.

Key Specifications

• OEM Part Numbers: 6195-0021 (female) / 6195-0024 (male)
• Pin Count: 6
• Gender: Male & Female set (with wire)
• Wire Gauge: 20 AWG (0.5 mm²)
• Wire Length: 5.5 inches (140 mm)
• Waterproof Rating: IP68
• Housing Material: PA66 glass-filled nylon
• Terminal Material: Copper alloy, tin-plated
• Current Rating: Up to 5A per pin

Throttle Pedal Sensor Pin Assignment (6-Pin Dual-Channel)

6195-0021 vs 6195-0024 – Female vs Male

In Sumitomo part numbering for this series, 6195-0021 = female housing (socket side) and 6195-0024 = male housing (pin side). Both are required for a complete mated connector pair.

Diagnosis – Throttle Pedal Faults

• P2135 (Throttle/Pedal Position Sensor Voltage Correlation): Most common code for this connector – caused by a corroded terminal creating a voltage offset between Channel 1 and Channel 2
• P0120–P0123 / P0220–P0223 (TPS/APPS Circuit): Check connector before replacing pedal assembly
• Limp mode / reduced power: ECU detects channel mismatch and limits throttle to 20–30% – inspect connector first

FAQ

Q: Is 6195-0021 the male or female connector?
A: 6195-0021 is the female (socket side); 6195-0024 is the male (pin side).

Q: Why does a throttle pedal sensor use 6 pins?
A: Electronic throttle control systems use two independent signal channels as a safety requirement. The ECU compares both channels continuously – if they diverge, it triggers a throttle fault and enters limp mode to prevent unintended acceleration.

Package Contents

1 × 6-Pin Male Connector (6195-0024) + 1 × 6-Pin Female Connector (6195-0021), each with 20 AWG wire and terminal insert