Dodge 4-Pin Wire Harness Connector – OEM F715600 | Female

The OEM F715600 is a 4-pin female connector used in Dodge vehicle harnesses. Dodge’s Chrysler-platform electrical architecture uses a range of compact 4-pin connectors across sensor, actuator, and module circuits. The F715600 serves power, ground, signal, and control circuits for Dodge electronic systems. Available bare or with 15cm pre-wired leads.

Key Specifications

Chrysler Platform Connector Reliability

Dodge vehicles on the Chrysler LX, LE, and WK platforms are known for connector corrosion issues in underhood and underbody locations, particularly in regions with road salt exposure. The F715600 connector is used in circuits where terminal corrosion causes intermittent sensor faults, actuator circuit errors, or module communication failures. On Dodge vehicles, these faults are diagnosed using the wiTECH or StarSCAN diagnostic systems. Replacing the connector is often the first step before replacing expensive sensors or modules.

Variant Guide

• Female – Bare 4-pin housing with terminals
• Female 15CM – Pre-wired with 15cm leads for direct splice-in installation

Installation Steps

1. Disconnect the vehicle battery
2. Locate the F715600 connector on the affected sensor or module harness
3. Release the locking tab and unplug the original connector
4. Transfer terminals to the new housing or splice in the pre-wired variant
5. Reconnect and clear fault codes with Dodge wiTECH or StarSCAN

Frequently Asked Questions

Q: What Dodge models use OEM F715600?
A: Cross-reference OEM F715600 with your Dodge vehicle’s wiring diagram to confirm fitment. This connector is used across multiple Dodge Chrysler-platform harnesses.

Q: Are terminals included?
A: Yes, terminals are included with all variants.

Compatible Applications

• Dodge Chrysler-platform sensor and actuator harness (OEM F715600)
• Module circuit connector repair
• Dodge 4-pin harness applications