17-Pin 2.2mm Headlight / Turn Signal / Fog / Wiper Combination Switch Controller Connector – OEM 7283-7375 / 6098-1998
Direct OEM-specification replacement for the Sumitomo 17-pin wire harness connector used on combination switch controllers (stalk switches) for headlights, turn signals, fog lights, and windscreen wipers. Cross-references Sumitomo OEM part numbers 7283-7375 and 6098-1998. Uses the 2.2mm contact series in white nylon and rubber housing — a high-density steering column connector that consolidates multiple lighting and wiper control circuits into a single 17-pin harness connection.
A failed connector causes multiple simultaneous lighting and wiper faults — depending on which pins have failed, the headlights, turn signals, fog lights, or wipers may become intermittent or inoperative. Multiple simultaneous lighting and wiper faults are a classic symptom of a failed 17-pin combination switch connector. Inspect the connector before replacing the stalk switch assembly or BCM.
| OEM Number | Application |
|---|---|
| 7283-7375 | Sumitomo 17-pin combination switch connector (female housing) |
| 6098-1998 | Sumitomo 17-pin combination switch connector (alternate) |
| Pin Group | Function | Failure Symptom if Open |
|---|---|---|
| Pins 1–4 | Headlight switch signals (off / position / low / high beam) | Headlight control inoperative |
| Pins 5–6 | Turn signal / indicator (left / right) | Indicator not flashing |
| Pins 7–8 | Fog light switch (front / rear) | Fog light control inoperative |
| Pins 9–12 | Wiper switch (off / intermittent / low / high) | Wiper speed control fault |
| Pins 13–17 | Washer, auto-wiper, illumination, ground | Washer or auto-wiper fault |
| Attribute | Detail |
|---|---|
| Pin Count | 17-Pin |
| Contact Series | 2.2mm pitch (Sumitomo series) |
| Housing Material | Nylon and rubber |
| Housing Colour | White |
| OEM Part Numbers | 7283-7375 / 6098-1998 |
| Applications | Combination switch (stalk switch), headlight / turn signal / fog / wiper controller |
| Terminal Included | Yes |
Q: My turn signals and wipers stopped working at the same time — could it be the combination switch connector?
A: Yes. Multiple simultaneous lighting and wiper faults are a classic symptom of a failed 17-pin combination switch connector. Inspect the connector before replacing the stalk switch assembly or BCM.
Q: Are terminals included?
A: Yes, terminals are included with all variants.
Be the first to know about new collections and special offers.
Automotive connector
