Nissan 12-Pin Front Bumper PDC & Radar Wire Harness Connector – Type A & B Female + Male OEM

This 12-pin connector is used in Nissan front bumper harnesses integrating Parking Distance Control (PDC) sensors and front radar module circuits. The 12-pin configuration consolidates multiple front bumper sensor circuits – PDC sensor power, ground, and signal circuits for multiple sensors, plus radar module power and CAN bus – into a single harness connector. Available in Type A Female, Type B Female, and Male variants, bare or with 15cm pre-wired leads.

Key Specifications

Front Bumper Harness – Why 12 Pins?

Modern Nissan front bumpers contain multiple sensors that must be wired through a single harness connector for serviceability. A typical Nissan front bumper with PDC and radar requires: 3 PDC sensors × 3 circuits each (power, ground, signal) = 9 circuits, plus radar module power (1 pin) and CAN bus (2 pins) = 12 circuits total. The Type A and Type B housing variants accommodate different bumper harness configurations where the connector geometry must match the bumper harness routing. When this connector corrodes, multiple PDC sensors and the radar module can fail simultaneously, generating a cascade of parking sensor and ACC/AEB fault codes.

Variant Guide

• Type A Female / A Female 15CM – Type A housing for specific bumper harness configuration
• Type B Female / B Female 15CM – Type B housing for alternate bumper harness configuration
• Male / Male 15CM – Plug-side connector

Frequently Asked Questions

Q: What Nissan models use this 12-pin front bumper connector?
A: This connector is used on Nissan Altima, Maxima, Rogue, X-Trail, Qashqai, and Infiniti Q50/Q60 front bumper PDC and radar harnesses. Cross-reference your vehicle’s wiring diagram to confirm fitment.

Q: What fault codes indicate a failed front bumper connector?
A: Common symptoms include multiple PDC sensor faults, ACC/AEB radar communication loss, and U-codes for radar module on Nissan CONSULT.

Q: Are terminals included?
A: Yes, terminals are included with all variants.

Compatible Applications

• Nissan Altima / Maxima – Front bumper PDC and radar harness
• Nissan Rogue / X-Trail / Qashqai – Front sensor harness connector
• Infiniti Q50 / Q60 – Front bumper multi-sensor wiring