Honda 12-Pin Electric Reversing System Wire Harness Connector – Male & Female OEM

This 12-pin connector is used in Honda electric reversing system harnesses, integrating reverse camera, parking sensor, rear display, and reverse signal circuits. The 12-pin configuration serves the complete reversing system module on Honda platforms. Available in Male and Female variants, bare or with 15cm pre-wired leads.

Key Specifications

Why Reversing System Connectors Fail

Honda reversing system connectors are exposed to vibration, thermal cycling, and moisture in the tailgate and rear bumper environment. Terminal corrosion or housing damage causes reverse camera signal loss, parking sensor failures, rear display blackouts, or U-code CAN bus communication faults with the reversing module. Replacing the connector restores full reversing system function.

Variant Guide

• Male / Male 15CM – Plug-side connector for the reversing module
• Female / Female 15CM – Socket-side connector for the harness side

Installation Steps

1. Disconnect the vehicle battery
2. Access the reversing system module connector in the tailgate or rear bumper area
3. Release the locking tab and unplug the original 12-pin connector
4. Transfer terminals to the new housing or splice in the pre-wired variant
5. Reconnect and verify reverse camera, parking sensor, and rear display function

Frequently Asked Questions

Q: What Honda models use this 12-pin reversing connector?
A: This connector is used on Honda Civic, Accord, CR-V, HR-V, and Acura ILX/TLX electric reversing system harnesses. Cross-reference your vehicle’s wiring diagram to confirm fitment.

Q: What fault codes indicate a failed reversing connector?
A: Common symptoms include reverse camera not displaying, parking sensor faults, and U-codes for reversing module communication errors on Honda HDS diagnostic systems.

Q: Are terminals included?
A: Yes, terminals are included with all variants.

Compatible Applications

• Honda Civic / Accord – Electric reversing system harness
• Honda CR-V / HR-V – Reverse camera and parking sensor connector
• Acura ILX / TLX – Reversing module wiring