Toyota / Nissan 2-Pin 2.2mm Steering Wheel Sensor Wire Harness Connector – OEM 7283-1822-70 / 90980-10850 / 90980-10849
Direct OEM-specification replacement for the Sumitomo 2-pin wire harness connector used on steering wheel sensors (steering angle sensors / clock spring sensors) across Toyota and Nissan platforms. Cross-references Sumitomo / Toyota OEM part numbers 7283-1822-70, 90980-10850, and 90980-10849. Uses the 2.2mm contact series in yellow nylon housing — the yellow housing colour is used by Toyota to identify steering system sensor connectors for quick identification during diagnosis and repair.
The 2-pin steering wheel sensor connector is located on the steering column, connecting the steering angle sensor or clock spring assembly to the body control module (BCM) or stability control system. A failed connector causes the steering angle sensor to lose its signal, triggering VSC (Vehicle Stability Control) fault codes, disabling the stability control system, and illuminating the VSC and ABS warning lights. On vehicles with electric power steering (EPS), a failed steering sensor connector can also cause EPS faults and loss of power steering assistance.
| OEM Number | Application |
|---|---|
| 7283-1822-70 | Sumitomo 2-pin steering sensor connector (primary) |
| 90980-10850 | Toyota OEM cross-reference (primary) |
| 90980-10849 | Toyota OEM cross-reference (alternate) |
| Pin | Function | Failure Symptom if Open |
|---|---|---|
| 1 | Sensor signal / power supply | VSC fault, stability control disabled |
| 2 | Ground / earth | Sensor inoperative, VSC and ABS warning lights |
| Attribute | Detail |
|---|---|
| Pin Count | 2-Pin |
| Contact Series | 2.2mm pitch (Sumitomo series) |
| Housing Material | Nylon, yellow |
| OEM Part Numbers | 7283-1822-70 / 90980-10850 / 90980-10849 |
| Applications | Steering angle sensor, clock spring, steering wheel sensor |
| Compatible Models | Toyota Corolla / Camry / RAV4 / Land Cruiser; Nissan Navara / X-Trail / Patrol |
| Terminal Included | Yes |
Q: My Toyota has VSC and ABS warning lights after a steering column repair — could it be the sensor connector?
A: Yes. A disconnected or damaged 2-pin steering angle sensor connector is a common cause of VSC and ABS warning lights after steering column work on Toyota vehicles. Inspect the yellow 2-pin connector before replacing the steering angle sensor or clock spring.
Q: Are terminals included?
A: Yes, terminals are included with all variants.
Be the first to know about new collections and special offers.
2 Pin Connectors
