Toyota & Honda 4-Pin Ignition Wire Harness Connector – OEM 6189-0229 / 6189-0763 / 90980-11152

A direct-fit OEM-specification 4-pin connector for ignition system wiring harnesses on Toyota and Honda vehicles. Matching OEM part numbers 6189-0229, 6189-0763, and 90980-11152, this connector provides a factory-quality electrical connection for ignition coil, igniter, and ignition circuit wiring repairs across compatible Toyota and Honda applications.

OEM Part Numbers

• 6189-0229
• 6189-0763
• 90980-11152

Key Specifications

• Pin Count: 4-pin
• Application: Ignition system wiring harness – Toyota and Honda ignition coil and igniter circuits
• Gender: Male or Female (select above)
• Lead Options: Bare connector or pre-wired lead (select above)
• Fit Type: Direct OEM replacement

Why Ignition Connectors Fail

Ignition coil connectors are exposed to extreme heat from the engine and high-voltage pulses from the ignition system. Over time, the housing cracks, the locking tab breaks, or the terminals corrode — causing:

• Cylinder misfire (P030x fault codes)
• Rough idle and hesitation under acceleration
• Ignition coil fault codes (P0350–P0362 series)
• Intermittent no-start conditions

Features & Benefits

• OEM-matched 4-pin layout: Precise pin configuration matches factory Toyota and Honda ignition harness connectors
• Three OEM cross-references: Covers 6189-0229, 6189-0763, and 90980-11152 variants
• Heat-resistant housing: Engineered to withstand ignition system heat and high-voltage environments
• Direct replacement: Plug-and-play fit with no modification to existing wiring
• Male and female options: Select the gender required for your specific repair

Frequently Asked Questions

Q: Which Toyota and Honda models use these OEM numbers?
A: Cross-reference OEM part numbers 6189-0229, 6189-0763, or 90980-11152 against your vehicle’s parts catalog or wiring diagram to confirm fitment.

Q: Should I replace the ignition coil and connector together?
A: If the connector shows heat damage or corrosion, inspect the coil as well. Replacing both together prevents repeat failure from a compromised electrical connection.

Q: Are terminals pre-installed?
A: Yes. Terminals are pre-installed in the connector housing.

Package Contents

1× 4-pin ignition wire harness connector (male or female, bare or pre-wired lead – select above)