6-Pin 0.6mm Accelerator Pedal & Throttle Valve Sensor Pigtail Connector for Benz & BMW – TE 1-967587-3 / 1-967616-1 with Wire
Direct OEM-specification replacement for the TE Connectivity 6-way 0.6mm pitch accelerator pedal and throttle valve sensor pigtail connector, cross-referencing part numbers 1-967587-3 (male) and 1-967616-1 (female). Supplied pre-wired with leads for direct splice-in repair without crimping tools.
| Attribute | Specification |
|---|---|
| OEM Part Numbers | 1-967587-3 (male) / 1-967616-1 (female) |
| Manufacturer | TE Connectivity |
| Vehicle Compatibility | Mercedes-Benz, BMW |
| Pin Count | 6-Way |
| Pitch | 0.6mm |
| Application | Accelerator pedal sensor (APPS), throttle valve sensor harness |
| Seal Type | Waterproof – sealed housing with wire seals |
| Supply Type | Pigtail – pre-wired with wire leads for splice-in repair |
| Operating Voltage | 12V DC (signal circuits) |
This pigtail variant is supplied with pre-installed wire leads, allowing direct splice-in repair of damaged accelerator pedal and throttle valve sensor harnesses without the need for a 0.6mm micro-crimping tool. Ideal for workshop and DIY repair applications where precision crimping tools are not available.
1 Set: 1 × 6-Way Male Pigtail (1-967587-3) + 1 × 6-Way Female Pigtail (1-967616-1) with pre-installed wire leads and wire seals.
Q: What is the advantage of a pigtail connector over a bare housing?
A: A pigtail connector comes with pre-installed wire leads, allowing direct splice-in repair without a crimping tool. This is ideal for workshop repairs where the damaged section of harness is cut out and the pigtail is spliced in using heat-shrink solder connectors or butt splices.
Q: Is this pigtail compatible with aftermarket accelerator pedals for Benz and BMW?
A: Yes, provided the aftermarket pedal uses the same 6-pin TE connector interface. Verify pin count and wire gauge against your pedal’s datasheet before installation.
Be the first to know about new collections and special offers.
6 Pin Connectors
