Citroën / Peugeot 4-Pin Wire Harness Connector – Female OEM

This 4-pin female connector is used in Citroën and Peugeot sensor, actuator, and module harnesses. The 4-pin configuration serves power, ground, signal, and control circuits across PSA Group vehicle platforms. Available bare or with 15cm pre-wired leads.

Key Specifications

Why PSA Connectors Fail

Citroën and Peugeot harness connectors are exposed to heat, vibration, and moisture in underhood and body applications. Terminal corrosion or housing damage causes intermittent sensor faults, actuator circuit errors, or module communication failures. Replacing the connector restores clean circuit continuity and eliminates ghost fault codes on Diagbox (PSA) diagnostic systems.

Variant Guide

• Female – Bare 4-pin housing with terminals
• Female 15CM – Pre-wired with 15cm leads for direct splice-in installation

Frequently Asked Questions

Q: What Citroën and Peugeot models use this 4-pin connector?
A: This connector is used across multiple PSA Group platforms including Citroën C3/C4/C5/Berlingo and Peugeot 206/307/308/3008 sensor and module harnesses. Cross-reference your vehicle’s wiring diagram to confirm fitment.

Q: Are terminals included?
A: Yes, terminals are included with all variants.

Compatible Applications

• Citroën C3 / C4 / C5 / Berlingo – Sensor and actuator harness
• Peugeot 206 / 307 / 308 / 3008 – Module circuit connector
• PSA Group 4-pin harness applications