2-Pin ABS Sensor / Fog Lamp / Turn Light Waterproof Connector – OEM 6189-0176 / 6188-0098 / 90980-11002 | Toyota Nissan Honda
Direct OEM-specification replacement for the Sumitomo 2-pin waterproof connector used on ABS wheel speed sensors, fog lamp harnesses, and turn signal / tail light circuits across Toyota, Nissan, and Honda platforms. Cross-references Sumitomo part numbers 6189-0176 (female housing), 6188-0098 (male housing), and Toyota OEM number 90980-11002. Uses the 2.2mm contact series in grey PA66 nylon housing with IP67 waterproof sealing.
The Sumitomo 2.2mm 2-pin connector is one of the most widely used small waterproof connectors in Japanese OEM wiring harnesses. ABS sensor connectors are particularly vulnerable — they are located at the wheel hub, exposed to road spray, brake dust, and repeated flexing during suspension travel. Corrosion on the ABS sensor pins causes intermittent or permanent wheel speed signal loss, triggering ABS, VSC, and traction control warning lights. Replacing the connector (rather than the entire ABS sensor) is the correct repair when the sensor itself tests within specification.
| OEM Number | Type | Application |
|---|---|---|
| 6189-0176 | Female housing (sensor side) | Sumitomo primary part number |
| 6188-0098 | Male housing (harness side) | Sumitomo primary part number |
| 90980-11002 | Female housing | Toyota OEM equivalent |
| Attribute | Detail |
|---|---|
| Pin Count | 2-Pin |
| Contact Series | 2.2mm pitch (Sumitomo series) |
| Housing Material | PA66 Nylon, grey |
| Sealing | Waterproof (IP67 equivalent) |
| OEM Part Numbers | 6189-0176 / 6188-0098 / 90980-11002 |
| Applications | ABS wheel speed sensor, fog lamp, turn signal, tail light |
| Compatible Brands | Toyota, Nissan, Honda (Sumitomo connector platform) |
| Terminal Included | Yes |
Yes. Toyota and Nissan standardised the Sumitomo 2.2mm 2-pin waterproof housing (6189-0176 / 6188-0098) across multiple low-current sensor and lighting applications. The housing is identical; only the terminal wire gauge and seal diameter differ by application. Verify the OEM part number on your existing connector before ordering to confirm compatibility.
Q: My ABS light is on and the wheel speed sensor tests OK — could it be the connector?
A: Yes. A corroded or damaged 2-pin ABS sensor connector is a common cause of intermittent wheel speed signal loss. The ABS module logs C0200–C0215 (wheel speed sensor circuit fault) when the signal is absent or erratic. Inspect and replace the connector before replacing the sensor.
Q: What fault codes does a failed ABS sensor connector cause?
A: Common DTCs include C0200 (RF wheel speed sensor circuit), C0205 (LF), C0210 (RR), C0215 (LR). On Toyota platforms, these also trigger VSC and TRAC OFF warning lights simultaneously.
Q: Can I replace just the connector without replacing the ABS sensor?
A: Yes. Cut the damaged connector from the existing harness, strip the wires, and crimp the new terminals onto the existing wires. This is the correct repair when the sensor resistance and output signal are within specification.
Q: Are terminals included?
A: Yes, terminals are included with all variants.
Be the first to know about new collections and special offers.
2 Pin Connectors
